sterowanie zpilota 4 kanały nowy #4

admin
Site Admin
Posty: 18
Rejestracja: sob lut 07, 2015 4:03 pm

sterowanie zpilota 4 kanały nowy #4

Postautor: admin » ndz cze 23, 2019 10:00 pm

#include <IRremote.h>

int RECV_PIN = 11; //

int output1 = 10;

int output2 = 6;

int output3 = 7;

int output4 = 8;

int itsONled[] = {0,0,0,0,0,0};


#define code1 0xE17AC23D //

#define code2 0xE17A40BF //

#define code4 0xA32AC03F //

#define code3 0xE17A20DF //

IRrecv irrecv(RECV_PIN);

decode_results results;

void setup() {

Serial.begin(9600); //

irrecv.enableIRIn(); //

pinMode(output1, OUTPUT);

pinMode(output2, OUTPUT);

pinMode(output3, OUTPUT);

pinMode(output4, OUTPUT);

}

void loop() {

if (irrecv.decode(&results)) {

unsigned int value = results.value;

switch(value) {

case code1:

if(itsONled[1] == 1) {

digitalWrite(output1, LOW);

itsONled[1] = 0; } else {

digitalWrite(output1, HIGH);

itsONled[1] = 1;

}

break;

case code2:

if(itsONled[2] == 1) {

digitalWrite(output2, LOW);

itsONled[2] = 0; } else {

digitalWrite(output2, HIGH);

itsONled[2] = 1;

}

break;

case code3:

if(itsONled[3] == 1) {

digitalWrite(output3, LOW);

itsONled[3] = 0; } else {

digitalWrite(output3, HIGH);

itsONled[3] = 1;

}

break;

case code4:

if(itsONled[4] == 1) {

digitalWrite(output4, LOW);

itsONled[4] = 0; } else {

digitalWrite(output4, HIGH);

itsONled[4] = 1;

}

break;

}

Serial.println(value); // you can comment this line

irrecv.resume(); // Receive the next value

}

}

zibi
Posty: 10
Rejestracja: pt cze 14, 2019 6:23 pm

Re: sterowanie zpilota 4 kanały nowy #4

Postautor: zibi » wt cze 25, 2019 2:22 pm

Działa extra. Teraz można za pomocą pilota od telewizora rozbudować funkcje sterowania poszczególnych urządzeń .
Kawał dobrej roboty.